 |
 |
|
|
|
|
|
|||||||
| RotorX Owners Forum Intended for discussions of owning, flying and building of RotorX helicopters. Moderators: Ron Curry |
|
|
Thread Tools | Display Modes |
|
#8
October21st, 2022
|
|||
|
|||
|
Re: Body Panel Fitting Issue
Justin,
Thanks! I put my tub in with a bit of frustration but it looks OK. The holes for the rear gear are too large. That's probably a job for future fiberglass work. Wade got back to me a week too late. Or rather I started cutting instead of waiting for his reply which would have saved a couple of days of repeat work. These photos are his. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear Lower Body Panel Vent Cut | Howard Schlei | Rotorway Owners Forum Archives 2010 | 10 | June11th, 2010 10:41 AM |
| DEL fitting seals | Dale Anderson | Rotorway Owners Forum Archives 2009 | 2 | February9th, 2009 03:06 PM |
| Body Panel Overlap | Don Charniak | Rotorway Owners Forum Archives 2005 | 6 | April28th, 2005 04:32 AM |
| battery case and body fitting | Dave Williams | Rotorway Owners Forum Archives 2003 | 4 | May29th, 2003 12:37 PM |
| Body Fitting (Or should I say not fitting) | Charlie Wuethrich | General Helicopter, Rotorway, and Aviation Forum | 3 | February16th, 2003 06:49 PM |
Threaded Mode