 |
 |
|
|
|
|
|
|||||||
| RotorX Owners Forum Intended for discussions of owning, flying and building of RotorX helicopters. Moderators: Ron Curry |
|
|
Thread Tools | Display Modes |
|
#7
October17th, 2022
|
||||
|
||||
|
Re: Body Panel Fitting Issue
I don't know about the new seat pan but in the past I have always set it as far to the pilot side as possible to allow for enough space for the pilot's left hand to fit between the collective and the collective pocket side wall. That area is usually a tight fit so a little more room there is desirable and moving the seat pan to the left helps a lot.
__________________
Orv Neisingh Rotorcraft/Helicopter Inst/ CFI/ A&P [email]orv@flywithorv.com[/email] [url]http://www.flywithorv.com[/url] Cell 417-464-9999 Home 417-255-2203 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear Lower Body Panel Vent Cut | Howard Schlei | Rotorway Owners Forum Archives 2010 | 10 | June11th, 2010 11:41 AM |
| DEL fitting seals | Dale Anderson | Rotorway Owners Forum Archives 2009 | 2 | February9th, 2009 04:06 PM |
| Body Panel Overlap | Don Charniak | Rotorway Owners Forum Archives 2005 | 6 | April28th, 2005 05:32 AM |
| battery case and body fitting | Dave Williams | Rotorway Owners Forum Archives 2003 | 4 | May29th, 2003 01:37 PM |
| Body Fitting (Or should I say not fitting) | Charlie Wuethrich | General Helicopter, Rotorway, and Aviation Forum | 3 | February16th, 2003 07:49 PM |
Threaded Mode