 |
 |
|
|
|
|
|
|||||||
| RotorX Owners Forum Intended for discussions of owning, flying and building of RotorX helicopters. Moderators: Ron Curry |
|
|
Thread Tools | Display Modes |
|
#14
June16th, 2023
|
|||
|
|||
|
Re: Vertical Stab Bracket
Getting the radius not too small and letting it cool slowly is very important but also you need to heat the metal from the Inside bend side which will tend to thicken the metal in the bend area; heating the metal on the outside bend area will tend to stretch and thin the metal and weaken this area. Al
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vertical Stab rear bracket | Mark Bosma | Rotorway Owners Forum Archives 2010 | 1 | September7th, 2010 08:51 PM |
| Horizontal Stab | Richard Hodges | Rotorway Owners Forum Archives 2010 | 19 | July9th, 2010 07:52 PM |
| Vertical stab... | Dale Anderson | Rotorway Owners Forum Archives 2009 | 9 | November17th, 2009 03:27 PM |
| Vertical stab mounting | Bill Kichman | Rotorway Owners Forum Archives 2007 | 9 | July6th, 2007 01:49 PM |
| Horiz stab mod | Justin Travis | JetExec Forum Archives 2005 | 34 | November14th, 2005 04:07 PM |
Threaded Mode