 |
 |
|
|
|
|
|
|||||||
| RotorX Owners Forum Intended for discussions of owning, flying and building of RotorX helicopters. Moderators: Ron Curry |
|
|
Thread Tools | Display Modes |
|
#13
June2nd, 2023
|
|||
|
|||
|
Re: Vertical Stab Bracket
Thanks Homer!
I only need to heat the area around the bend line, right?, not the whole part? And to cool it down slowly, would it work to put the part after heating to dull read and bending in a preheated oven (I think goes up to 450F), turn it off and let it cool? Last edited by Fredy Irizarry; June2nd, 2023 at 10:21 AM. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vertical Stab rear bracket | Mark Bosma | Rotorway Owners Forum Archives 2010 | 1 | September7th, 2010 08:51 PM |
| Horizontal Stab | Richard Hodges | Rotorway Owners Forum Archives 2010 | 19 | July9th, 2010 07:52 PM |
| Vertical stab... | Dale Anderson | Rotorway Owners Forum Archives 2009 | 9 | November17th, 2009 03:27 PM |
| Vertical stab mounting | Bill Kichman | Rotorway Owners Forum Archives 2007 | 9 | July6th, 2007 01:49 PM |
| Horiz stab mod | Justin Travis | JetExec Forum Archives 2005 | 34 | November14th, 2005 04:07 PM |
Threaded Mode