 |
 |
|
|
|
|
|
|||||||
| RotorX Owners Forum Intended for discussions of owning, flying and building of RotorX helicopters. Moderators: Ron Curry |
|
|
Thread Tools | Display Modes |
|
#11
June1st, 2023
|
|||
|
|||
|
Re: Vertical Stab Bracket
Hi, New A600 builder here :-).
I have seen the reference many times to "use heat" when bending the tail fin brackets, but I am not sure "how hot" is right. Does it have to be cherry red, just turning red, or can I use an infrared thermometer and heat to a specific temperature? Another question is, the cool down, I just let it air cool slowly right? Any advice would be greatly appreciated! 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vertical Stab rear bracket | Mark Bosma | Rotorway Owners Forum Archives 2010 | 1 | September7th, 2010 07:51 PM |
| Horizontal Stab | Richard Hodges | Rotorway Owners Forum Archives 2010 | 19 | July9th, 2010 06:52 PM |
| Vertical stab... | Dale Anderson | Rotorway Owners Forum Archives 2009 | 9 | November17th, 2009 02:27 PM |
| Vertical stab mounting | Bill Kichman | Rotorway Owners Forum Archives 2007 | 9 | July6th, 2007 12:49 PM |
| Horiz stab mod | Justin Travis | JetExec Forum Archives 2005 | 34 | November14th, 2005 03:07 PM |
Threaded Mode