 |
 |
|
|
|
|
|
|||||||
| RotorX Owners Forum Intended for discussions of owning, flying and building of RotorX helicopters. Moderators: Ron Curry |
|
|
Thread Tools | Display Modes |
|
#9
October24th, 2022
|
|||
|
|||
|
Re: Body Panel Fitting Issue
I think I will need a new tub. A week ago I cut mine based on the manual and video. In order to get it off the frame after the first body fit I’ll need to expand the gear leg holes to about 4” diameter. My warning to new builders, cut the tub based on Wade’s photos above, NOT the builder’s manual, video and pre-etched gear holes.
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear Lower Body Panel Vent Cut | Howard Schlei | Rotorway Owners Forum Archives 2010 | 10 | June11th, 2010 11:41 AM |
| DEL fitting seals | Dale Anderson | Rotorway Owners Forum Archives 2009 | 2 | February9th, 2009 04:06 PM |
| Body Panel Overlap | Don Charniak | Rotorway Owners Forum Archives 2005 | 6 | April28th, 2005 05:32 AM |
| battery case and body fitting | Dave Williams | Rotorway Owners Forum Archives 2003 | 4 | May29th, 2003 01:37 PM |
| Body Fitting (Or should I say not fitting) | Charlie Wuethrich | General Helicopter, Rotorway, and Aviation Forum | 3 | February16th, 2003 07:49 PM |
Threaded Mode