Re: Vertical Stab Bracket
yes, I scaled up the templates. I think they are correct after I scaled them up. And have fabricated a test one from aluminum as advised in the instructions. And just eyeballing it I'm sure I'm going to have the same issue as you had on the lower mounting point with rivets. But I'm also wondering how far the standoff is from the tailboom. I didn't actually get the vertical fin with my group 1. It's backordered until they don't know when. So I can't hold it up and kind of get an idea of how everything will go, not that it matters. If the first angles from the mount were 90 degrees say, then it would be easier to figure out. But looking at the drawings, construction video, and written instructions, it doesn't look as there is anything specific. Just make it vertical and bolted to the #4 bulkhead seem to be the only "for sure" part of the installation of that bracket.
|