[Eric Anderson]

The two photos in my previous post. The most important part is the 46” measurement from the back of the tub to the cut. Wade, by the way, is the guy you will most likely chat with when you hit a snag. He's also the guy who does most of the cad work. Many, if not all, of the drawings are his. Mark Peterson's Factory Tour video from earlier this summer is a great introduction to Wade, Stan, Kris and others. I should also further clarify that you certainly will and should use the manual and video to hang the body. Just don't use the pre-etched gear holes in the gel coat to gauge your cut.